Panasonic CT-32D12D Operating Instructions Manual

Contents

Panasonic CT-32D12D Operating Instructions Manual Manual pdf 13 page image

R EMOTE CONTROL O PERATION11 lProgramming The RemoteThe Universal Remote Control can be programmed to operate many manufacturers’ components, using the componentfunction buttons for VCR, DVD, CABLE or DBS. Follow the procedures for programming your Remote Control with orwithout a code for the component.Determine the manufacturer of the component and look in the table for the code.Programming With a CodeProcedure• Confirm that the external component is plugged in and operating.• Turn the component off.• Press and together, for at least 5 seconds.• Press appropriate component button on the Remote Control VCR, DVD, CABLE or DBS.• Enter the 3-digit component code using the Remote Control numeric keypad (0 ~ 9 buttons).• Press the Remote Control to test the component. If the procedure was successful, the component will turn on.Programming Without a CodeThis procedure searches all codes and is called the “sequence method.”• Confirm that the external component is plugged in and on.• Turn the component off.• Press and together, for at least 5 seconds.• Press appropriate component button on the Remote Control.• Press to move forward to the next code. Press to move backward.• Press the Remote Control to test the component. If the procedure was successful, the component will turn on.Note: Repeat the above steps until the component code is found. It may take many attempts before the correct codeis found.• After the code is found, press to store the code.Default Modes For Remote ControlDevice Operates DefaultTV TV (Panasonic Only) Panasonic TV CodesVCR VCR (Preset) Panasonic VCR CodesDBS DBS (Preset) Panasonic DBS CodesCABLE CABLE (Preset) Panasonic DBS CodesDVD DVD, CD (Preset) Panasonic DVD CodesHelpful Hints: Unsuccessful CodeIf the component does not operate with the Remote Control, repeatthe procedure using another code. (Some brands have multiplecodes).If an incorrect code is entered, or if the procedure takes longer than30 seconds, the programming will fail.ACTIONPOWERPOWERACTIONPOWERVOL VOLPOWERACTION