Panasonic CT-31G10 Operating Instructions Manual

Panasonic CT-31G10 Operating Instructions Manual Manual pdf 3 page image

14.Ifanoutsideantennaisconnectedtothetelevisionequipment,be_uJe[t_e,_ _telu_d _y_tem _syrounued so _ LopJovluesome protection against voltage surges and built up static charges. In the U.S. Section 810 of the National ElectricalCode and in Canada Part I of the Canadian Electrical Code provides information with respect to proper grounding of themast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors,location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.See Figure.15. For added protection for this television receiver during a lightning storm, or when it is left unattended and unused for longperiods of time, unplug it from the wall outlet and disconnect the antenna. This will prevent damage to the receiver due tolightning and power-line surges.16. An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or powercircuits, or where it can fall into such power lines or circuits. When installing an outside antenna system extreme careshould be taken to keep from touching such power lines or circuits as contact with them might be fatal.17. Unplug this television receiver from the wall outlet, and refer servicing to qualified service personnel under the followingconditions:a. When the power cord or plug is damaged or frayed.b. If liquid has been spilled into the television receiver.c. If the television receiver has been exposed to rain or water.d. If the television receiver does not operate normally by following the operating instructions. Adjust only those controlsthat are cove red by the operating instructions as improper adjustment of other controls may result in damage and willoften require extensive work by a qualified technician to restore the television receiver to normal operation.e. If the television receiver has been dropped or the cabinet has been damaged.f. When the television receiver exhibits a distinct change in performance- this indicates a need for service.18. Do not attempt to service this television receiver yourself as opening or removing covers may expose you to dangerousvoltage or other hazards. Refer all servicing to qualified service personnel.19. When replacement parts are required, be sure the service technician has used replacement parts specified by themanufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire,electric shock, or other hazards.20. Upon completion of any service or repairs to this television receiver, ask the service technician to perform routine safetychecks to determine that the television is in safe operating condition.21. WARNING: To prevent fire or shock hazard, do not expose this appliance to rain or moisture.22. CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN RECEPTACLE OROTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.NOTE: This equipment is designed to operate in the U.S.A., Canada and other countries where the broadcasting system andAC house current is exactly the same as in the U.S.A. and Canada.Important Information Regarding Use of Video Games, Computers, Teletext or Other Fixed Image Displays.The extended use of fixed image program material can cause a permanent "shadow image" on the picture tube. Thisbackground image is viewable on normal programs in the form of a stationary fixed image. This type of irreversible picturetube deterioration can be limited by observing the following steps:A. Reduce the brightness/contrast setting to a minimum viewing level.B. Do not display the fixed image for extended periods of time.C. Turn the power off when not in actual use.NOTE: The marking or retained image on the picture tube resulting from fixed image use is not an operating defect and assuch is not covered by Warranty. This product is not designed to display fixed image patterns for extended periods oftime.Power Source:Channel Capability:Video Input Jacks (2):Audio Input Jacks (2):1"o Audio AMP Jacks:S-_HS Input Jack:Stereo SoundClosed Caption Disp|a¥Specifications120V, 60Hz, AC18.1 channels (See chart)VHF 2~13, UHF 14~69, Cable 125 channelslV p-p, 75 ohm, phono jack typeHigh impedance- 10K ohm, 500mY rms0-4.0V rms 10K ohmS-k/_deo (_'-C_ ConnectorSpecifications are subject to change without notice or obligation.Channel Capability ChartBAND USA/CANVHFUHFCABLE (Mid-Band)CABLE (Super Band)CABLE (Hyper Band)CABLE (,Ultra Band)TOTAL CHANNEt'S125615142856181-3-