Panasonic CT-31G10 Operating Instructions Manual

Panasonic CT-31G10 Operating Instructions Manual Manual pdf 11 page image

TV/Video Button - Press the TV/VIDEO buttonto select desired input.TV/VIDEOSignal connected to:REAR VIDEO/AUDIO INPUT 2 JACKS/REAR VIDEO/AUDIO _____INPUT 1 JACKSTV or CABLEVIDEO 2 Iv,o o,IICH;;Recall Button - Press the RECALL button toreview:• Audio Mode status• CH number or Video Input selected• Sleep Timer status• Clock time• Channel Caption (Station Identifier)RECALL SAP CH 03MONO XYYZO 29 1:00R-Tune (Rapid Tune) Button - PresstheR-TUNE (RAPID TUNE) button to instantly switchbetween the last two channels selected (without any OnScreen display being activated).R-TUNECHANNEL HOWBEING VIEWEDCHANNEL TUNEDIMMEDIATELY BEFORE_ Press Button _ /_ress Butt°n Again I i,t,"Multi Button --The MULTI button can beprogrammed to operate up to 6 Remote functionbuttons at the same time. For Example: TVPower/On, VCR Power/On (selected brands) can beoperated at the same time with one press of the MULTIbutton.Procedure1. First program the Remote for the selected VCRInfra-red access code. Confirm that the RemoteControl is compatible with the equipment.2. Face the Remote Control transmitter away from allequipment remote sensors.3. Press and hold Remote TV Power button, thenpress and hold the MULTI button down simulta-neously. (All previous commands are erased.)(TV) POWER MULTIPRESS SIMULTANEOUSLY4. Press a maximum of 6 Function buttons on theRemote.Each button you press is equal to one function. If sixRemote button functions are entered, all will registerin the MULTI button memory in the sequenceentered. When less than six Remote buttonfunctions are entered, press the MULTI button toend the program mode. (Waiting more than 30seconds without pressing another button will alsoend the program mode.)The following is an example of Remote functionsthat can be programmed into the MULTI button,TV Power- For turning TV ON and OFF.VCR Power - For turning VCR ON and OFF(selected brands after programming it's Infra-redaccess code, if necessary).Both can be turned ON or OFF with one press of theMULTI button.NOTE: To activate VCR Power or Cable box Poweror other VCR/Cable box functions, the TV/CABLEswitch must be put into the proper mode during Multibutton program.(TV) POWER VCR POWER MULTITo delete entered functions - Press the RemoteTV POWER and MULTI buttons simultaneously.Now you can enter from one to six different Remotefunctions.('FV) POWER MULTINOTE: PRESS SIMULTANEOUSLYYou can also program the MULTI button to performmost individual Remote Control button functions.Buttons which continuously perform a function aslong as pressed (Volume Up/Down, ChannelUp/Down, etc.) cannot be programmed. Only thosebuttons which perform a function when initiallypressed (,Power On/Off, Mute, Direct Channet Entry,etc.) can be programmed.-11 -