Panasonic CF-VDW07BH Operating Instructions Manual

Panasonic CF-VDW07BH Operating Instructions Manual Manual pdf 6 page image

6FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLYThis appliance is supplied with a moulded three pin mains plug for your safety and convenience.A 3 amp fuse is fitted in this plug.Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 3amps and that it is approved by ASTA or BSI to BS 1362.Check for the ASTA mark A S Aor the BSI mark on the body of the fuse.If the plug contains a removable fuse cover you must ensure that it is refitted when the fuseis replaced.If you lose the fuse cover the plug must not be used until a replacement cover is obtained.A replacement fuse cover can be purchased from your local Panasonic Dealer.IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET INYOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFFAND DISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG ISINSERTED INTO ANY 13 AMP SOCKET.If a new plug is to be fitted please observe the wiring code as shown below.If in any doubt please consult a qualified electrician.ImportantThe wires in this mains lead are coloured in accordance with the following code:Blue: NeutralBrown: LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with thecoloured markings identifying the terminals in your plug, proceed as follows:The wire which is coloured Blue must be connected to the terminal which is marked with theletter N or coloured BLACK.The wire which is coloured Brown must be connected to the terminal which is marked withthe letter L or coloured RED.Under no circumstances should either of these wires be connected to the earth terminal ofthe three pin plug, marked with the letter E or the Earth Symbol .The mains plug on this equipment must be used to disconnect the mains power.Please ensure that a socket outlet is available near the equipment and shall be easily accessible.How to replace the fuseOpen the fuse compartment with a screwdriver and replace the fuse.WarningsThis equipment is not designed for connection to an IT power system.(An IT system is a system having no direct connections between live parts and Earth; theexposed-conducive-parts of the electrical installation are earthed.An IT system is not permitted where the computer is directly connected to public supplysystems in the U.K.)Disconnect the mains plug from the supply socket when the computer is not in use.This equipment is produced to BS800/1983.For U.K.