Panasonic BB-HCM705A - Fixed MP H.264 Dome POE Indoor Network Camera Installation Manual

Also see for BB-HCM701: Comparison chart Important information

Contents

Panasonic BB-HCM705A - Fixed MP H.264 Dome POE Indoor Network Camera Installation Manual Manual pdf 1 page image

1Installation GuideNetwork Camera (PoE Ready)This manual is written for both the BB-HCM701 and the BB-HCM705. Available features and operations vary slightly depending on the model. You canconfirm the model no. of your camera by checking the model no. printed on the front of the camera.Model number suffixes (“A” and “CE”) are omitted from the following model numbers shown in this document, unless necessary.BB-HCM701A, BB-HCM701CE, BB-HCM705A, BB-HCM705CEPlease read the included Important Information before proceeding.Complete Operating Instructions and all other documentation can be found on the included CD-ROM.Model No. BB-HCM701BB-HCM705Indoor Use OnlyIndoor Use OnlyInstallation Procedure OverviewThe following is an overview of the steps required to install and setup the camera. All steps are explained in this document unless otherwise noted.Preparation1. Confirm the following items are included in the camera’s packaging.2. You will need the following additional items to install and configure the camera.OptionYou can also connect the camera using the optional Panasonic BB-HCA7A, BB-HCA7CE or BB-HCA7E AC adaptor. The optional AC adaptor includes thefollowing items. (For more information, consult your authorized Panasonic dealer.)• The AC adaptor, the AC adaptor cord, the AC cord, and the extension cord are not splash resistant, and are intended for indoor use only. The AC adaptor, theAC adaptor cord, the AC cord, and the extension cord must be waterproofed for outside use.PreparationConfirm that you have all theitems required forinstallation.Camera DiagramMake sure you know thenames of the camera’sphysical features.ConnectionsConnecting the camera toyour network and to the poweroutlet.SetupSetting up the camera (described in the includedSetup Guide). This involves configuring the cameraso that it can be accessed from a PC.MountingMounting or placing thecamera.Main Unit (1 pc.) Bit (1pc.)[BB-HCM701CE/BB-HCM705CE Only]Order No. PNMH1086ZUsed to secure thecamera cover.Screw A (4 pcs.)Order No. XTB4+20AFJUsed to secure thecamera (3 pcs.) and thesafety wire to the ceiling(1 pc.).Screw B (1 pc.)Order No.XTB26+10GFJUsed for connecting thesafety wire to thecamera.Washer A (1 pc.)Order No.XWG4F16VWUsed when securing thesafety wire to the ceiling.Washer B (1 pc.)Order No.XWG26D12VWUsed when securing thesafety wire to thecamera.Safety Wire (1 pc.)Order No.PQME10080ZUsed to secure thecamera when mountingit.Template (1 pc.)Order No. PNPD1302ZUsed when markingholes for the cables andscrews.Important Information (1 pc.)Installation Guide (this document) (1 pc.)Setup Guide (1 pc.)Stand-alone SD Memory Card Recording Guide (1 pc.)Setup CD-ROM (1 pc.) Order No. PNQC1016NContains the Setup Program needed to configure the camera, as well as thecamera’s documentation.**See the included Important Information for a description of each document.– a PC (see the system requirements in the Important Information document) – a LAN cable (CAT-5 straight cable)– a routerBB-HCA7AAC Adaptor (1 pc.)Cord Length: About 3 m(9 feet 10 inches)AC Cord (1 pc.)Cord Length: About 1.8 m(5 feet 11 inches)Extension Cord (1 pc.)Cord Length: About 7 m(23 feet)BB-HCA7CE (2 pin AC cord)AC Adaptor (1 pc.)Cord Length: About 3 m(9 feet 10 inches)AC Cord (1 pc.)Cord Length: About 1.8 m(5 feet 11 inches)Extension Cord (1 pc.)Cord Length: About 7 m(23 feet)BB-HCA7E (3 pin AC cord)AC Adaptor (1 pc.)Cord Length: About 3 m(9 feet 10 inches)AC Cord (1 pc.)Cord Length: About 1.8 m(5 feet 11 inches)Extension Cord (1 pc.)Cord Length: About 7 m(23 feet)© Panasonic System Networks Co., Ltd. 2009PNQX1983XA KK0709CQ3129Please read this document before using the product, and save this document for futurereference. Panasonic Network Camera Website:http://panasonic.net/pcc/ipcam/• This document (Installation Guide) explains how to physically connect thecamera to the power supply and network, as well how to mount or place thecamera for regular use.• The Setup Guide describes how to set up the camera so that it can beaccessed using a PC.• Refer to the Operating Instructions on the CD-ROM for details regardingthe camera’s features.• Refer to the Troubleshooting Guide on the CD-ROM if you have anyproblems configuring or using the camera.• The Stand-alone SD Memory Card Recording Guide describes how torecord images to an SD memory card without using a PC.Abbreviations• UPnP is the abbreviation for “Universal Plug and Play”.• The Network Camera is referred to as “the camera” in this document.• The Setup CD-ROM is referred to as “the CD-ROM” in this document.• The term “SD memory card” is used in this document to refer to SD memorycards and SDHC memory cards.

/ 4

Related manuals for Panasonic BB-HCM701