Panasonic AW-HE40 Installation & Setup Manual

Also see for AW-RP50: Operating instructions Operating instructions Brochure & specs Brochure & specs Quick start guide

Panasonic AW-HE40 Installation & Setup Manual Manual pdf 1 page image

●This is to explain the procedure for allowing AW-HE40 series cameras to be used viaAW-RP50 controller.For detailed explanations, please see each Operating Instructions.【IP Connection】(Point) Through a hub, AW-RP50 controller can control up to 100 remote cameras.Connect [LAN] on AW-RP50 rear panel and [LAN ACT/LINK] on AW-HE40 rear panel using a LAN cable.【Serial Connection】(Point) The cable can be extended up to 1,000m.AW-RP50 controller can control up to five AW-HE40 cameras via serial connection.Connect TO PAN/TILT HEAD [1] – [5] on AW-RP50 rear panel and [RS-422] on AW-HE40 rear panel usinga LAN cable.※TO PAN/TILT HEAD ports [1] – [5] correspond to AW-RP50 connection settings “CAM1” – “CAM5”,respectively.If you want to use AW-RP50 “CAM3” for serial controlling of the camera, please connect a LAN cablewith TO PAN/TILT HEAD port [3].Remote Camera Installation & Setup Guide1． Connecting the LAN Cable(AW-RP50 Rear Panel) (AW-HE40 Rear Panel)HUB(LAN Cable)Category 5 or higher, Up to 100m(LAN Cable)Category 5 or higher, Up to 100m< For PoE+ Hub >Category 5e or higher, Up to 100m(AW-RP50 Rear Panel) (AW-HE40 Rear Panel)(LAN Cable)Category 5 or higher, Up to 1,000mStraight cableDirect Connection(Through a hub)