Panasonic AU-VREC1 Firmware Update Procedures

Firmware update procedureRecording module: AU-VREC1,Camera module: AU-V23HS1, AU-V35C1NOTE:Ver. 2.03: After AU-V35C1 is updated, please perform ABB with the lens capfitted on according to the procedure stated in this update manual.This is for the sensor adjustment needed after 120p mode is newly equipped.Only the first ABB adjustment after the update is definitive. It cannot bedone over again.Please be careful because, if it is not successfully completed, the productwill not work correctly when you use it.1. How to check firmware version1. Connect Camera module to Recording module. Switch ON the power of the camera recorder.2. Press MENU button. Select “> SYSTEM SETTINGS >INFORMATION >VERSION” to display the currentversion with the Jog Dial button.Camera moduleRecording moduleVersion displayexampleNOTE: The firmware versions of the camera module and the recording module must match to operate this unit.Firmware of the camera module can be updated only when the recording module is connected.CAMERA : AU-V23HS1SERIAL NO : H4TAA0003PRODUCT VERSION : 0.35-06-9.18RECORDER : AU-VREC1SERIAL NO : L4TAA0004PRODUCT VERSION : 0.35-06-9.18Jog Dial buttonMENUbutton

/ 5

Related manuals for Panasonic AU-V23HS1