– 30 –Error ItemsWhen the WARNING lamp is lightedDescriptionThis is displayed when the fan motor stops.FAN STOPMonitor display VTR operationOperation continuesThis is displayed when the error rate increases andcorrection/interpolation is performed on either the video oraudio playback signal.HIGH ERROR RATE Operation continuesThis is displayed when envelope levels approximately 1/3that of normal levels are detected for more than onesecond during playback, recording, or editing.LOW RF Operation continuesThis is displayed when the servo is not locked for three ormore seconds during playback, recording, or editing.SERVO NOT LOCKED Operation continuesThis appears during playback when a blank section (tapeblank) lasting for one or more seconds has been detected.Such a section is identified as a tape blank when all of thefollowing conditions are met.O No head outputsO No playback data readoutO No CTLNO RF Operation continuesWhen the AUTO OFF lamp is lightedDescriptionIf the capstan motor speed is abnormally low, the AUTOOFF lamp lights, and the message display flashes.CAP ROTATE TOO SLOWMonitor display VTR operationSTOP(POWER OFF 5 ON)If an abnormal tension at the supply side is detected in thecapstan mode, the AUTO OFF lamp lights, and themessage display flashes.CAP TENSION ERROR STOP(POWER OFF 5 ON)If condensation is detected, the AUTO OFF lamp lights,the message display flashes, and the VTR is transferred tothe eject mode. After the tape is ejected, the drum rotatesin order to eliminate the condensation.When the condensation has been eliminated, the AUTOOFF lamp and message display go off, and the VTR canbe used.O If condensation is detected in the eject mode, the drumstarts rotating as soon as it is detected.O If condensation is detected when the cassette has beeninserted, the drum rotation is stopped, and after thetape is ejected, the drum starts rotating.DEW EJECT(Normal operation resumedafter condensation iseliminated)If the cylinder motor speed is abnormally high, the AUTOOFF lamp lights, and the message display flashes.DRUM ROTA TOO FAST STOP(POWER OFF 5 ON)