Panasonic AG-HPD24P Operating Instructions Manual

Contents

Panasonic AG-HPD24P Operating Instructions Manual Manual pdf 39 page image

3D Recording/Playback Mode (3D REC/PB): Displaying and Managing Clips 393D Recording/Playback Mode (3D REC/PB)The same operations for viewing and revising clip informationas in main mode are available. However, viewing and revisingcan only be performed for the master (L) side clip.◆ NOTE:• Clip data cannot be revised for Dual P2 3D clips where the masterside and slave side materials have been incorrectly inserted orwhere the master or slave side is missing.• Clip data on a dual P2 3D clip with only a slave side will not beproperly displayed.Thumbnails can be revised like in main mode. However,revising can only be performed for the master (L) side clip.◆ NOTE:• Thumbnails cannot be revised on Dual P2 3D clips where the masterside and slave side materials have been incorrectly inserted orwhere the master or slave side is missing.Meta data can be added to a recorded clip like in main mode.However, additions can only be made to clips on the master(L) side.P2 cards can be formatted like in main mode. However, thisoperation formats all P2 cards (slots cannot be specified) on boththe master side and slave side devices.1 Open the thumbnail screen.2 Press the MENU button.3 Use the Up/Down/Left/Right cursor buttons tochoose the OPERATION - FORMAT - ALL P2 menusetting and press the SET button.◆ NOTE:• Selecting SD CARD will format an SD memory card inserted inthe SD memory card slot on the master side.4 Select YES and press the SET button.Formatting of all cards starts.◆ NOTE:• To cancel formatting, select NO and press the SET button.• Check that no important data remains on a card beforeformatting since data erased by formatting cannot berecovered.5 When the completion message appears, select OK(press the SET button).6 Press the MENU button to end processing.◆ NOTE:• It is not possible to format the cards if any of the inserted P2 cardsis write protected.Like in main mode, you can use the following steps to displayand check P2 card slot status, P2 card usage and other cardinformation on the screen. You can check both the masterside and the slave side on the master unit.1) Display P2 card status for the master side.On the master side, remaining recording time for slot 1 and2 and used capacity are indicated on the meter and as atime value (minutes).2) Display P2 card status for the slave side.On the slave side, remaining recording capacity for slot 1and 2 and used capacity are indicated on the meter andas a time value (in minutes).Viewing and Revising ClipInformationThumbnail EditingAttaching Meta data to Clips DuringRecordingFormatting P2 Cards3,42,63,4,5Checking Card Status1)2)3)