Panasonic AG-HPD24P Operating Instructions Manual

Contents

Panasonic AG-HPD24P Operating Instructions Manual Manual pdf 36 page image

36 USB Device Mode:USB Device ModeA USB 2.0 connection with a PC allows you to use P2 cardsinserted in the slots on this unit as mass storage. Note that aseparate USB driver (found on the supplied CD-ROM) mustalso be installed on the PC.Use of P2 viewer, which can be downloaded from thefollowing site, free of charge, allows you to manipulate clipsstored on a P2 card on a Windows PC.For details on the URL (➝ “Website URL” page 2)◆ NOTE:• For details regarding connections, refer to the OperatingInstructions supplied with the PC and the application software.1 Press the MODE button when this unit is idle.2 Select USB DEVICE in the confirmation dialog andpress the SET button.“USB DEVICE” flashes on the LCD monitor to indicate thatthe unit is entering the USB host mode. After the modeswitch, “USB DEVICE DISCONNECT” appears on the LCDmonitor.This message is replaced by a “USB DEVICE CONNECT”message when the connection with the PC is completed.◆ NOTE:• Selecting 3D REC/PB or SYNC PB mode disables modechanges until communications with the slave device areestablished. When an incorrect mode is selected, turn thepower off and then back on again to change modes.3 Use USB device mode operations.◆ NOTE:• Please refer to the operating instructions supplied with your PCand software.4 Press the MODE button to return to regular mode.◆ NOTE:• Recording, playback and most of other operations are notavailable in the USB device mode.• When using a Windows PC, install the driver using the suppliedCD-ROM.21,4