Panasonic AG-HPD24P Operating Instructions Manual

Contents

Panasonic AG-HPD24P Operating Instructions Manual Manual pdf 38 page image

38 3D Recording/Playback Mode (3D REC/PB): Displaying and Managing ClipsLike in main mode, you can customize the thumbnail screento suit operating conditions and improve efficiency.(➝ “Viewing and Revising Clip Information” page 39)◆ NOTE:• Some menu functions do not comply with the 3D REC/PB mode.Like in main mode, select clips you want to process on thethumbnail screen.(➝ “Selecting and Deselecting Clips” page 16)Clips other than Dual P2 3D clips will not be displayed asthumbnails and require main mode to be viewed properly.Playback is performed like in main mode.◆ NOTE:• During playback and variable speed playback, the clip cannot beforwarded or rewound. Press the STILL button to engage still (SHTL0.0) mode before performing these operations.• Text memo forward/rewind is not possible in 3D REC/PB mode.• Video and audio distortion between clips may occur when playingback clips with different video formats (1080i and 720p), or differentcompression formats (AVC-Intra 50 and AVC-Intra 100).The master side provides variable playback like main mode.However, since the slave side will not operate at the sametime, 3D video cannot be viewed. Video output during variablespeed playback depends on the output signal system.• Independent right and left systems: Video is shown only onthe LCD and no output is made to SDI/HDMI.However, when the SETUP - VIDEO - DISCRETE BLACKmenu setting is set to OFF, the master side outputs videoonly via the SDI/HDMI outputs.• Side-by-side, frame packing system: Only video from the Lside is output to the LCD and SDI/HDMI (video on the R sideis identical to L side video).◆ NOTE:• Clip seek is not performed during playback. Use seek from STILL(SHTL 0.0) status.• When the stop state is controlled by an external device, depending onthe control system, video output and non-output conditions may differ.Text memos and shot marks can be added like in main mode.However, additions can only be made to clips on the master(L) side.Clip copying cannot be performed.You can delete clips like in main mode. Note that clips on boththe master (L) side and the slave (R) side are deleted.◆ NOTE:• Clips on a Dual P2 3D clip where the master and slave sides havebeen incorrectly inserted can also be deleted.• You can also delete clips on a Dual P2 3D clip where the master orslave side is missing. Take care as a Dual P2 3D clip where themaster or slave side is missing cannot be played back.• A clip that spans across multiple P2 cards cannot be deleted if anyof the cards is write protected.Clips with bad clip indicators (yellow ) can be repaired inthe same way as in main mode.The reconnect function cannot be used in 3D REC/PB mode.◆ NOTE:• Use main mode to reconnect incomplete clips.Changing Thumbnail DisplaySelecting and Deselecting ClipsPlaying Back ClipsVariable Speed PlaybackAdding Text Memos and Shot MarksCopying ClipsDeleting ClipsRepairing and Reconnecting ClipsRepairing bad clipsReconnecting incomplete clips