Setting Procedure3-163.4 Settings of Connection Using FP0H as Target3.4.1 SettingsThis section describes the setting method of the connection using the FP0H as target,The FP0H(A) in the figure below is an object for the setting.Ten word data is sent from the data area (LD30 to 39) of the FP0H(A) to the data area (LD30to 39) of FP7.FP0H（A）IP：192.168.1.5LD40LD49LD30LD39FP7LD30LD39IP：192.168.1.6OriginatorTargetTag_Test1Tag_Test1Set in I/O map.• When the FP0H is used as target, only the data transmission to originator is available.• Register a tag (Tag_Test1) specified from the FP7 (Originator) in the "I/O map".• Set the data area (LD30 to 39) corresponding to the tag.
