OHAUS T51P Instruction Manual

Also see for T51P: Quick start guide Service manual Instruction manual User guide

OHAUS T51P Instruction Manual Manual pdf 47 page image

EN-46 5000 Series Indicators4.8.4 Check WeighingUse this mode to determine if the weight of a sample is within prescribed limits.Checkweighing LimitsWhen the FUNCTIONMode button is released, CLr.rEF is displayed.Clearing Stored Check Weighing LimitsPress the Yes button to clear the stored limits.Recalling Stored Check Weighing LimitsPress the No button to recall the stored limits.NOTE: Press the FUNCTIONMode button to temporarily display the Under and Over Limit values.Editing the Under SettingThe display shows SEt.LO. Press the Yes button to edit setting..Settings:-999950 to 999950Refer to Menu Navigation Section 3.2 to enter settings.NOTE: The minus sign is used together with the first digit to show a negative value.Editing the Over SettingThe display shows SEt.HI.Press the Yes button to edit the Over setting.Settings:-999950 to 999950Refer to Menu Navigation Section 3.2 to enter settings.Begin Check WeighingThe appropriate Under, Accept or Over LED lights to indicate Check Weigh status.Place a sample on the scale and read the weight.For loads less than the Under Limit, the yellow Under LED is lit.For loads greater than the Under Limit and less than the Over limit, the green Accept LED is lit.For loads greater than the Over Limit, the red Over LED is lit.towww. GlobalTestSupply .comFind Quality Products Online at: sales@GlobalTestSupply.com