OHAUS Ranger RP Instruction Manual

OHAUS Ranger RP Instruction Manual Manual pdf 16 page image

Ranger RP16OperationWith automatic start PrerequisiteAVErAGE -> AUtO is selected in the menu.The weighing sample must be heavier than 5 scale divisions.1. Place the weighing sample on the scale.The scale starts the dynamic weighing automatically.During dynamic weighing, horizontal segments appear in the display, and thedynamic result is then displayed with the symbol *.2. Unload the scale to be able to perform a new dynamic weighing operation.2.7 Weighing-in to a target weight and checkweighingThe compact scales Ranger RP allow the weighing-in of goods to a particular targetweight within defined tolerances. With this function it is possible to checkwhether weighing samples are within a defined tolerance range.The compact scales Ranger RP have a total of 100 memory locations for frequentlyused tare values, average piece weights, target weights and target quantities.In the factory setting, the memory locations 81 to 90 are reserved for target weights.The saved target weights are also preserved when the scales are switched off.2.7.1 Saving target weights1. Enter the memory location number (factory setting: 81 ... 90) and keep Mempressed until the confirmation tArGEt appears in the display.2. Enter the target weight in the defined unit, e.g. 1.5 kg, and confirm with Yes.The display tOLER appears and + flashes.3. Enter the upper tolerance in the displayed weight unit, e.g. 0.1 kg, and confirm withYes-or-Press Yes, enter the upper tolerance range in percent and confirm with Yes.The display tOLEr appears and – flashes.4. Enter the lower tolerance accordingly.The scale returns to weighing mode.Note If a target weight had already been saved under the selected memory location, themessage rEPLACE appears in the display.• To save the new target weight, press Yes. The old target weight is overwritten.• To abort the save process, press No. The previous memory location assignmentremains valid.