OHAUS CS Series Quick Start Manual

Also see for CS Series: Quick start guide

OHAUS CS Series Quick Start Manual Manual pdf 1 page image

Quick Start Guide CS Series ScalesOhaus Corporation www.ohaus.com i CS Series Scales Quick Start GuidePREPARATION FOR USECheck PowerFor AC power, be sure local line voltagematches voltage printed on the scale’s poweradapter. If not, do not use AC power.To use battery power, remove battery coverand insert three LR6 (AA) batteries.Remove Spacer, Install PanRemove the red transport spacer: slide it backand off. Place the stainless steel pan (ifprovided) on the weighing platform. (The scalecan be operated without the pan, if desired.)Allow at least 30-60 seconds warm-up time,for scale to stabilize before operation.SELECTING THE LOCATION: Place on a firm, steady surface with sufficient space.Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.SAFETY PRECAUTIONSFor dependable operation of this product, observe the following precautions:• Verify that the input voltage printed on the power Adapter and the plug typematches the local power supply (if using AC power).• Make sure that the power cord does not pose an obstacle or tripping hazard.• Disconnect the product from the power supply when cleaning.• Do not operate this product in hazardous or unstable environments.• Do not drop loads on the pan.• Use only approved accessories and peripherals, as available.• Operate the product only under ambient conditions specified in the InstructionManual.• Service should be performed by authorized personnel only.Remove redtransportSpacerStainlesssteel panrests atopweighingplatform.

/ 2

Related manuals for OHAUS CS Series