OHAUS CL Series Quick Start Manual

Also see for CL Series: Instruction manual Instruction manual User guide Instruction manual

Contents

selecting the location

OHAUS CL Series Quick Start Manual Manual pdf 1 page image

Quick Start Guide CL Series ScalesOhaus Corporation www.ohaus.com i CL Series Scales Quick Start GuidePREPARATION FOR USERelease LocksBefore using the scale, release theTransportation Lock. On scale bottom,slide the locking pin to the position.Check PowerEnsure voltage identification label matcheslocal line voltage. If not, do not connect theunit. Contact Ohaus or your dealer.To use battery power, remove battery coverand insert three LR6 (AA) batteries.Allow at least 30-60 seconds warm-up time,for scale to stabilize before operation.SELECTING THE LOCATION: Place on a firm, steady surface with sufficient space.Avoid excessive air current, vibrations, heat sources, or rapid temperature changes.SAFETY PRECAUTIONSFor dependable operation of this product, observe the following precautions:• Verify that the input voltage printed on the power Adapter and the plug typematches the local power supply (if using AC power).• Make sure that the power cord does not pose an obstacle or tripping hazard.• Disconnect the product from the power supply when cleaning.• Do not operate this product in hazardous or unstable environments.• Do not drop loads on the pan.• Use only approved accessories and peripherals, as available.• Operate the product only under ambient conditions specified in the InstructionManual.• Service should be performed by authorized personnel only.TransportationLockPower Input JackRemoveBatteryCover toinsert 3Batteries:LR6 (AA).

/ 2

Related manuals for OHAUS CL Series