OHAUS CKW-55 Instruction Manual

Also see for CKW Series: Quick start guide Installation and operation instructions

Contents

OHAUS CKW-55 Instruction Manual Manual pdf 29 page image

CKW-55 CHECKWEIGHER EN-25Reviewing Library DataTo review Library data, the Library must be set On.If the library is Off, pressing the LIBRARYSave button will display the message -NO-, andreturns to the active weighing mode.Press LIBRARYSave button, the last active Library location and Part Number will be displayed.Press the NEXT +/- button to advance to another Library, or press LIBRARYSave button toreview the current Library data. Continue to press LIBRARYSave button until all data has beenreviewed. When END is displayed, press the TARE Exit button to cancel and exit, or pressLIBRARYSave button then NEXT +/- button to continue reviewing additional Libraries.Erasing Library DataAccess the desired Library to be removed using the LIBRARYSave button and NEXT +/- button.Repeatedly press the LIBRARYSave button until END is displayed. Long press the C button,the Library ID is displayed, then CLEAR is displayed. The contents of the selected Library iserased.3.6 Scale SettingsThis section describes the settings available in each menu.3.6.1 Setup MenuAccess this Menu to configure metrological parameters.ResetThis menu item is used to reset the Setup menu to the factory defaults.Note: Capacity and graduation settings are not reset.Selections are: No, YesLegal for tradeThis menu item is used to enable or disable Legal for trade compliant operation.Selections are: OFF, On.Note: Certain menu items are restricted as shown in Section 3.3.1.Calibration UnitThis menu item is used to define the unit of measure for calibration.Selections are: kg, lb.Full Scale CapacityThis menu item is used to define the capacity setting of the scale.The display flashes the last Full Scale Capacity value entered.If a different Full Scale Capacity value is desired, enter the new value via the numeric keypad.Values entered are whole numbers from 3 to 100,000 (refer to Appendix E).Note: Changes will require a re-calibration for correct operation.GraduationThis menu item is used to define the scale readability. The display flashes the last Graduationvalue entered. If a different Graduation value is desired, enter the new value via the numerickeypad.