en Fault, what to do?38Fault tableFault Cause Remedial actionError code “:‚‰ is lit. Supply hose kinked. Install supply hose without kinks.Tap turned off. Turn on the tap.Tap jammed or calcified. Turn on the tap.Flow rate must be min. 10 l/min. whenwater supply is open.Filter in the water supply blocked. Switch off the appliance and pull out themains plug. Turn off the tap. Unscrewwater connection.Clean filter in the supply hose. Screwwater connection on again. Check forleaks. Reconnect power supply. Switch onthe appliance.Error code “:‹ˆ is lit. Intake opening (on right inside ofappliance) covered by utensils.Arrange utensils so that the intakeopening is not obstructed.Error code “:‚ƒ is lit. Heating element calcified orsoiled.Clean appliance with dishwasher cleaningagent or descaler. Operate the dishwasherwith water softening system and check thesetting. ~ " Water softeningsystem/special salt" on page 14Error code “:ƒƒ is lit. Filters 1j are soiled orblocked.Clean filters. ~ "Filters" on page 35Error code “:ƒ… is lit. Waste-water hose kinked orblocked.Install hose without kinks, remove anyresidue.Siphon connection still sealed. Check connection to siphon and open ifrequired.Cover on the waste water pumploose.Lock cover correctly. ~ "Waste waterpump" on page 37Error code “:ƒ† is lit. Waste water pump blocked orcover on the waste water pump isnot locked in position.Clean pump and lock cover correctly.~ "Waste water pump" on page 37