27 After UsePreparation: Make sure that the projector is turned off.1. Unplug the power cable.2. Disconnect any other cables.3. Retract adjustable tilt foot if extended.4. Cover the lens with the lens cap.5. Put the projector and accessories in the supplied soft case.Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens fromdamage.3. Projecting an Image (Basic Operation)NOTE: When placing the projector in the soft case, retract the tilt foot and the rear feet. Failure to do so may case damage to theprojector.CAUTION:Use caution when putting the projector in the soft case immediately after the projector has been operating. Theprojector cabinet is hot.MENUSELECTLAMPSTATUSPOWERON/STAND BYSOURCEAUTO ADJ.ENTEREXITFOCUSZOOMMENUSELECTLAMPSTATUSPOWERON/STAND BY SOURCEAUTO ADJ.ENTEREXITInsert the projector with the lensfacing upward
