NEC VT700 User Manual

Also see for VT700: Specifications Control commands Command guide Command guide Control commands

Contents

NEC VT700 User Manual Manual pdf 16 page image

81. IntroductionRemote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry immediately.• Avoid excessive heat and humidity.• Do not heat, take apart, or throw batteries into fire.• If you will not be using the remote control for a long time, remove the batteries.• Ensure that you have the batteries’ polarity (+/-) aligned correctly.• Do not use new and old batteries together, or use different types of batteries together.• Dispose of used batteries according to your local regulations.Operating Range for Wireless Remote Control1 Press firmly and slide thebattery cover off.2 Install new batteries (AAA).Ensure that you have thebatteries' polarity (+/–) alignedcorrectly.• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle ofthe remote sensor on the projector cabinet.• The projector will not respond if there are objects between the remote control and the sensor, or if strong light fallson the sensor. Weak batteries will also prevent the remote control from properly operating the projector.Battery InstallationMENUSELECTEXITENTERLAMPSTATUSPOWERON/STAND BY AUTO ADJ.SOURCE30°30°30°30°FOCUSZOOM7m/22feet7m/22feetRemote controlRemote sensor on projector cabinet3 Slip the cover back over thebatteries until it snaps into place.Do not mix different types ofbatteries or new and old batteries.