Setup and Operation 2-15USING AUTO SETUP TO SELECT PARAMETERSUse the steps below to review or change system parameters.1. When no error messages exist, choose a parameter option from the menu bar bypressing the appropriate highlighted character in the menu.To select “Comms” press C. A window shows a parameter menu and the pa-rameter's current setting. Go to step 3.If an error message occurred during POST, use Auto Setup as follows:n Note the blinking double carets (>>) that mark the changed parameter(s).n Either accept the change(s) by pressing Enter and return to the Auto SetupSummary screen, orn Change the parameter to the correct setting using the steps that follow.2. Press Tab or the arrow keys to place the cursor on the parameter.3. Press the Alt ↓↓ to view the parameter settings. A list of parameter choices ap-pears.To select a setting, press Alt ↓↓ to position the cursor on the appropriate setting.Press Enter. Auto Setup processes the change, exits the window and returns tothe parameter menu.Press Esc to return to the summary screen without saving changes.4. Press X to exit the menu bar.5. Use ↓↓ to select “Exit and Save Changes” and press Enter.6. Press Enter again. The system reboots with the latest changes.
