NEC PlasmaSync 42XR4 Operation Manual

Also see for 50XR5: Supplementary guide Supplementary guide Specifications Installation guide Supplementary guide

Contents

NEC PlasmaSync 42XR4 Operation Manual Manual pdf 8 page image

En-6Back of the unitmounting holesBack of the unitmounting holescablesclampmounting holeON/STANDBYApprox.7m/23ftUsing the remote controlBattery Installation and ReplacementInsert the 2 “AAA” batteries, making sure to set them inwith the proper polarity.1.Press and open the cover.2.Align the batteries according to the (+) and (–) indicationinside the case.Handling the remote control• Do not drop or mishandle the remote control.• Do not get the remote control wet. If the remote controlgets wet, wipe it dry immediately.• Avoid heat and humidity.• When not using the remote control for a long period,remove the batteries.• Do not use new and old batteries together, or use differenttypes together.• Do not take apart the batteries, heat them, or throw theminto a fire.Operating Range* Use the remote control within a distance of about 7 m/23ft. from the front of the monitor’s remote control sensorand at horizontal and vertical angles of up to approximately30°.* The remote control operation may not function if themonitor’s remote control sensor is exposed to directsunlight or strong artificial light, or if there is an obstaclebetween the sensor and the remote control.Cable ManagementUsing the cable clamps provided with the plasma display;Bundle the signal and audio cables at the back of the unitto connect to the display.42 inch50-61 inchTo attachTo detach1. 2.3.Replace the cover.