945. Using On-Screen Menu[OPTIONS(2)]Selecting Power-saving in [STANDBY MODE]The projector has two standby modes: [NORMAL] and [POWER-SAVING].The POWER-SAVING mode is the mode that allows you to put the projector in the power-saving condition whichconsumes less power than the NORMAL mode. The projector is preset for NORMAL mode at the factory.NORMAL���������������� Power indicator: Orange light/STATUS indicator: Green lightPOWER-SAVING ���� Power indicator: Red light/STATUS indicator: OffThe following connectors, buttons or functions will not work during this mode�- MONITOR OUT (COMP�) connector, and AUDIO OUT connector- LAN and Mail Alert functions- Buttons other than POWER button on the cabinet- Buttons other than POWER ON button on the remote control- Virtual Remote Tool, USB Display fucntionNOTE:• When [CONTROL PANEL LOCK], [CONTROL ID], or [AUTO POWER ON(COMP.)] is turned on, the [STANDBY MODE] setting isnot available.• Even when [POWER-SAVING] is selected for [STANDBY MODE], power on or off can be done by using the PC CONTROL port.• The power consumption in the standby mode will not be included in calculating CO2 emission reduction.• Your setting will not be affected even when [RESET] is done from the menu.Enabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.
