NEC MultiSync V801 User Manual

Also see for MultiSync V801: Manual Manual Specification Manual Installation guide

NEC MultiSync V801 User Manual Manual pdf 8 page image

English-6Attaching Mounting AccessoriesThe monitor is designed for use with the VESA mountingsystem.1. Attach eyebolts (not included) formountingThis model is equipped with attachable eyebolts to aid inmounting.• Screw the eyebolts into eyebolt holes as shown in thepicture.• Be sure eyebolts are secure.• In order to move the monitor into position, use a liftingdevice attached to the eyebolts.DO NOT mount the monitor using only the eyebolts.Eyebolt HoleEyebolt (M10) (not included)2. Attach Mounting AccessoriesBe careful to avoid tipping monitor when attachingaccessories.VESA Mounting Interface400 mm400 mmMounting accessories can be attached with the monitor inthe face down position. To avoid damaging the screen face,place the protective sheet on the table underneath the LCD.The protective sheet was wrapped around the LCD in theoriginal packaging. Make sure there is nothing on the tablethat can damage the monitor.When using mounting accessories other than NEC compliantand approved, they must comply with the VESA-compatiblemounting method.NOTE: • Do not leave the monitor in the face-up or face-down position for more than one hour as thismay result in a negative effect on the screen’sperformance.• Prior to installation, be sure to place the monitoron a fl at area with adequate space.Mounting location• The ceiling and wall must be strong enough to support themonitor and mounting accessories.• DO NOT install in locations where a door or gate can hitthe unit.• DO NOT install in areas where the unit will be subjectedto strong vibrations and dust.• DO NOT install near where the main power supply entersthe building.• Do not install in where people can easily grab and hangonto the unit or the mounting apparatus.• When mounting in a recessed area, as in a wall, leave atleast 4 inches (100 mm) of space between the monitorand the wall for proper ventilation.• Allow adequate ventilation or provide air conditioningaround the monitor, so that heat can properly dissipateaway from the unit and mounting apparatus.Mounting on ceiling• Ensure that the ceiling is sturdy enough to support theweight of the unit and the mounting apparatus over time,against earthquakes, unexpected vibrations, and otherexternal forces.• Be sure the unit is mounted to a solid structure withinthe ceiling, such as a support beam. Secure the monitorusing bolts, spring lock washers, washer and nut.• DO NOT mount to areas that have no supporting internalstructure. DO NOT use wood screws or anchor screws formounting. DO NOT mount the unit to trim or to hangingfi xtures.Maintenance• Periodically check for loose screws, gaps, distortions,or other problems that may occur with the mountingapparatus. If a problem is detected, please refer toqualifi ed personnel for service.• Regularly check the mounting location for signs ofdamage or weakness that may occur over time.