NEC MultiSync V652-TM User Manual

Also see for MultiSync V463: Manual Manual Specification Installation guide Product specifications

NEC MultiSync V652-TM User Manual Manual pdf 16 page image

English-141. Determine the installation locationCAUTION: Installing your LCD monitor must be done by aqualifi ed technician. Contact your dealer for moreinformation.CAUTION: MOVING OR INSTALLING THE LCD MONITORMUST BE DONE BY FOUR OR MORE PEOPLE.Failure to follow this caution may result in injury ifthe LCD monitor falls.CAUTION: Do not mount or operate the monitor upsidedown, face up or face down.CAUTION: This LCD has a temperature sensor and coolingfans, including a fan for option board.If the LCD becomes too hot, the cooling fans willturn on automatically.The fan of option board is active although thetemperature is lower than normal operatingtemperature for cooling option board. If the LCDbecomes overheated while the cooling fan isrunning, a “Caution” warning will appear. If the“Caution” warning appears, discontinue use andallow the unit to cool. Using the cooling fan willreduce the likelihood of early circuit failure andmay help reduce image degradation and “ImagePersistance”.If the LCD is used in an enclosed area or if theLCD panel is covered with a protective screen,please check the inside temperature of themonitor by using the “HEAT STATUS” controlin the OSD (see page 26). If the temperature ishigher than the normal operating temperature,please turn the cooling fan to ON within the FANCONTROL menu within the OSD (see page 26).IMPORTANT: Lay the protective sheet, which was wrappedaround the LCD monitor when it waspackaged, beneath the LCD monitor so as notto scratch the panel.2. Install the remote control batteriesThe remote control is powered by two 1.5V AA batteries.To install or replace batteries:A. Press and slide to open the cover.B. Align the batteries according to the (+) and (–) indicationsinside the case.C. Replace the cover.CAUTION: Incorrect usage of batteries can result in leaks orbursting.NEC recommends the following battery use:• Place “AA” size batteries matching the (+) and (-) signson each battery to the (+) and (-) signs of the batterycompartment.• Do not mix battery brands.• Do not combine new and old batteries. This can shortenbattery life or cause liquid leakage of batteries.• Remove dead batteries immediately to prevent batteryacid from leaking into the battery compartment.• Do not touch exposed battery acid, it may injure skin.NOTE: If you do not intend to use the Remote Control fora long period of time, remove the batteries.3. Connect external equipment(See pages 16 and 17)• To protect the external equipment; turn off the main powerbefore making connections.• Refer to your equipment user manual for furtherinformation.NOTE: Do not connect/disconnect cables when turningon the monitor or other external equipment as thismay result in a loss of the monitor image.4. Connect the supplied power cord• The equipment should be installed close to an easilyaccessible power outlet.• Please fasten power cord to the LCD monitor by attachingthe screw and clamp.• Fully insert the prongs into the power outlet socket.A loose connection may cause image degradation.NOTE: Please refer to the “Safety Precautions andMaintenance” section of this manual for properselection of AC power cord.ClampScrewSetup