272. Projecting an Image (Basic Operation) Turning off the ProjectorTo turn off the projector:1. First, press the (POWER) button on the projectorcabinet or the POWER OFF button on the remote con-trol.The [POWER OFF / ARE YOU SURE? / CARBON SAV-INGS- SESSION 0.000[g-CO2]] message will appear.2. Secondly, press the ENTER button or press the(POWER) or the POWER OFF button again.The lamp will turn off and the projector will go into standbymode. When in standby mode, the POWER indicator willlight orange and the STATUS indicator will light green when[NORMAL] is selected for [STANDBY MODE].Power OnSteady blue lightStandbySteadyorange lightCAUTION:Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if theAC power supply is disconnected during normal projector operation.Use caution when picking up the projector.NOTE:• While the power indicator is blinking blue in short cycles, the power cannot be turned off.• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closingthe menu. Doing so can cause loss of adjustments and settings.
