1046. Installation and ConnectionsCOMPUTER 1 IN COMPUTER 1 INHDMI INUSB(PC)AUDIO INHDMI INUSB(PC)Computer cable (VGA) (supplied)To mini D-Sub 15-pin connector on the projector. It isrecommended that you use a commercially avail-able distribution amplifier if connecting a signal cablelonger than the cable supplied.A commercially availableUSB cable(compatible with USB 2.0specifications)NOTE: For Macintosh, use a commercially available pin adapter (notsupplied) to connect to your Mac’s video port.Stereo mini-plugaudio cable (notsupplied) Making ConnectionsNOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby modeand before turning on the power to the notebook PC.In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power manage-ment software.Enabling the computer’s external displayDisplaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector.When using a PC compatible laptop, a combination of function keys will enable/disable the external display.Usually, the combination of the “Fn” key along with one of the 12 function keys gets the external display to come onor off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle throughexternal display selections.Connecting Your ComputerNOTE: Signals supported by Plug & Play (DDC2)INPUTCOMPUTER 1 IN COMPUTER 2 IN HDMIanalog analog digitalYes Yes YesHDMI cable (not supplied)Use High Speed HDMI®Cable.NOTE: The M420XV does not come with theAUDIO IN connector (stereo mini jack).M420XV
