NEC HT410 User Manual

Also see for HT410 Series: Supplementary guide Control commands Command guide Command guide Control commands

Contents

NEC HT410 User Manual Manual pdf 32 page image

E-213. PROJECTING AN IMAGE (BASIC OPERATION)This section describes how to turn on the projector and to project a picture onto the screen.Turning on the ProjectorNOTE:• The projector has two power switches: a main power switch and an ON/STAND BY button.• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (O)position. Failure to do so may cause damage to the projector.To turn on the main power to the projector, press the Main Power switch to the on ( I ) position.The POWER indicator will light orange.Before you turn on your projector, ensure that the computer or video source is turned on and that your lens capis removed.Only after you press the ON/STAND BY button on the projector cabinet or POWER ON button on the remotecontrol for a minimum of 2 seconds will the power indicator turn to green and the projector become ready to use.POWER POWER POWERSTATUSLAMPSTATUSLAMPSTATUSLAMPStandby Blinking Power OnSteady orange light Blinking greenlightSteady greenlightSee page E-49 for more details.LAMPSTATUSPOWERAUTOADJ.ON/STAND BYSELECTSOURCEMENUPOWEROFFS-VIDEOC-VIDEOVIDEO COMP.COMPUTERCOMPONENTAUTOAUTO ADJ.ONRemote controlCabinet controlsCONTROLS-VIDEO INRCb/PbYL/monoSTATUSLAMPPOWERNOTE: The POWER and STATUS (LED) indicators blinking green at the same time indicates the main power was interruptedduring previous operation. Wait for 60 seconds (cooling period) to see if the lamp turns on by itself.3. PROJECTING AN IMAGE (BASIC OPERATION)