4-44 System Configuration11. Mount the PCI Module #1 again to the NEC Express5800/ft series (see page 8-31“Installing PCI Module”) and plug the power cord to the AC inlet B (for Group1). (ThePOWER Switch LED will be turned on.)12. Likewise, mount the PCI Module #2 to the NEC Express5800/ft series and plug the powercord to the AC inlet A (for Group2).13. Shortly after you connect the both power cords, the BMC status LED on PCI Module #2will start to blink.14. When Password clear is completed, the BMC status LED will go off.CHECK:The BMC status LED blinks to show that synchronous processing is being performedbetween the two modules. When this process is complete, Password has also beencleared on PCI Module #2.TIPS: For the location of the AC inlet A, the AC inlet B, see “NAMES AND FUNCTIONSOF COMPONENTS” in Chapter 2. For the location of the BMC status LED, see “NAMES AND FUNCTIONS OFCOMPONENTS” in Chapter 2. For description of the BMC status LED, see “LEDs” in Chapter 2.
