FPΣ 6.2 Function Specifications and Restricted Items6 - 56.2 Function Specifications and Restricted ItemsThis section contains specifications and restriction of functions.6.2.1 Table of SpecificationsHigh - speed counter function specificationsInput/output contactnumber being usedBuilt-inhigh -speedMemory area being used PerformancespecificationsRelatedinstruc-tionsOn/offoutputCountinputmodeInputcontactnumber(valuein pa-renthe-sis isresetinput)*Note 1speedcounterchan-nel no.ControlflagElapsedvalueareaTargetvalueareaMini-muminputpulsewidth*Note 2MaximumcountingspeedtionsSpecifythedesiredoutputfromAdditioninput,Sub-tractioninp tX0(X2)CH0 R903A DT90044toDT90045DT90046toDT9004710 μs · Usingone channel:Max. 50 kHz(×1- channel)pfromY0 to Y7usinginstruc-tioninput X1(X2)CH1 R903B DT90048toDT90049DT90050toDT90051( )· Usingtwo channels:Max. 30 kHz(×2- channel)tionX3(X5)CH2 R903C DT90200toDT90201DT90202toDT90203· Usingthree channels:Max. 20 kHz(×3- channel)F0 (MV),F1(DMV),F166X4(X5)CH3 R903D DT90204toDT90205DT90206toDT90207· Usingfour channels:Max. 20 kHz(×4- channel)( )F166(HC1S),F167(HC1R)Specifythedesiredoutputfrom2-phaseinput,One in-put,Direc-X0X1(X2)CH0 R903A DT90044toDT90045DT90046toDT9004725 μs · Usingone channel:Max. 20 kHz(×1- channel)fromY0 to Y7usinginstruc-tionDirec-tion dis-tinctionX3X4(X5)CH2 R903C DT90200toDT90201DT90202toDT90203· Usingtwo channels:Max. 15 kHz(×2- channel)Notes1) Reset input X2 can be set to either CH0 or CH1. Reset input X5can be set to either CH2 or CH3.2) For information on min. input pulse width, see page 6 - 12.
