12 Part Number 020002365 08/25/2015Installation Section 2Installer InstructionsImportantThe remainder of these instructions is to be completedby an authorized Multiplex Installer.These equipment instructions are intended to assistqualified personnel in the unpacking, locating and theinitial operation of the Multiplex Beverage Equipment PostMix Refrigeration Unit.ImportantThis publication must be saved for future reference.Read instructions before attempting installation.PREPARATIONThe Multiplex Beverage Equipment Post Mix RefrigerationUnit is pre-assembled in the factory and requires minimuminstallation.For future reference or to be used when ordering parts,record the Model Number, Serial Number, Part Numbersof Unit, Condenser (if remote), Towers, etc., and Date ofInstallation on the inside of this Manual. Leave manual onsite in a safe place. Do not discard manual.Ambient Location RequirementThis equipment is rated for indoor use only. It will notoperate in sub-freezing temperature. In a situation whentemperatures drop below freezing, the equipment must beturned off immediately and properly winterized. Contactthe manufacturer for winterization process.ElectricalGENERALnWarningAll wiring must conform to local, state and nationalcodes.MINIMUM CIRCUIT AMPACITYThe minimum circuit ampacity is used to help select thewire size of the electrical supply. (Minimum circuit ampacityis not the beverage/ice machine’s running amp load.)The wire size (or gauge) is also dependent upon location,materials used, length of run, etc., so it must be determinedby a qualified electrician.ELECTRICAL REQUIREMENTSRefer to Ice Machine Model/Serial Plate for voltage/amperage specifications.SPECIFICATIONSModel Volt/Cycle/PhaseMinimum CircuitAmpsBreaker Compressor4244208-230/60/1230/50/120.620.630A25A1 hp0.75 kWSC1000 208-230/60/1230/50/120.620.630A25A1 hp0.75 kW50 208-230/60/3230/400/50/325.211.630A20A2.2 hp1.6 kWSC2000 208-230/60/3230/400/50/325.211.620A15A2.2 hp1.6 kW