Makita LS1040 Instruction Manual

Also see for LS1040: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

Contents

17 ENGLISHCrown molding stoppers (optional accessories) alloweasier cuts of crown molding without tilting the sawblade. Install them on the base as shown in the figures.312► 1. Crown molding stopper L 2. Crown molding stop-per R 3. BasePosition crown molding with its WALL CONTACT EDGEagainst the guide fence and its CEILING CONTACTEDGE against the crown molding stoppers as shown inthe figure. Adjust the crown molding stoppers accordingto the size of the crown molding. Tighten the screws tosecure the crown molding stoppers. Refer to the table(C) for the miter angle.123 4► 1. Guide fence 2. Crown molding 3. Crown moldingstopper 4. ScrewPosition inFig. A Miter angle Finished piece(1) Right 45° Save the right side of blade(2) Save the left side of blade(3) Save the right side of blade(4) Right 45° Save the left side of bladeLeft 45°For insidecornerFor outsidecornerTable (C)Cutting aluminum extrusion12345► 1. Vise 2. Spacer block 3. Guide fence 4. Aluminumextrusion 5. Spacer blockWhen securing aluminum extrusions, use spacer blocksor pieces of scrap as shown in the figure to preventdeformation of the aluminum. Use a cutting lubricantwhen cutting the aluminum extrusion to prevent build-upof the aluminum material on the blade.CAUTION:• Never attempt to cut thick or round aluminumextrusions. Thick aluminum extrusions maycome loose during operation and round alumi-num extrusions cannot be secured firmly withthis tool.Wood facingUse of wood facing helps to assure splinter-free cutsin workpieces. Attach a wood facing to the guide fenceusing the holes in the guide fence.See the figure concerning the dimensions for a sug-gested wood facing.Over 10mm (3/8") Over 460mm (18-1/8")1 190mm(3-9/16")25mm(1")90mm(3-9/16")107mm(4-7/32")90mm(3-9/16")107mm(4-7/32")1. HoleCAUTION:• Use straight wood of even thickness as thewood facing.• Use screws to attach the wood facing to theguide fence. The screws should be installed sothat the screw heads are below the surface ofthe wood facing.• When the wood facing is attached, do not turnthe turn base with the handle lowered. Theblade and/or the wood facing will be damaged.

/ 64

Related manuals for Makita LS1040

Makita LS1040 Instruction Manual

This manual is suitable for:

LS1040 LS1040F

Makita LS1040 Instruction Manual

Product

Learn More

Legal