Makita LS0714 Technical Information

Also see for LS0714: Instruction manual Instruction manual Instruction manual Parts Breakdown Instruction manual

1R207 : 45 degrees set square1R208 : 90 degrees set square[16] Angle adjustment of saw blade1. Adjust the angle of saw blade at 90° against turn base using 90 degrees set square (Makita Part No.1R208). See Fig. 15-1.While keeping this condition, fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm. See Fig. 15-2.2. As for 45 ° degrees adjusting, use 45 degrees set square as Fig. 15-3.After that the fix the angle by adjusting 0° degrees bevel angle adjusting bolt at the side of arm as Fig. 15-4.Fig. 15-1Fig. 15-345°90°Fig. 15-2Fig. 15-4ArmArm0 degrees bevel angle adjusting bolt(Hex bolt M6x16)45 degrees bevel angle adjusting bolt(Hex bolt M6x16)45°90°[17] Adjustment for max. cutting capacityDo the following steps to obtain the max. cutting capacity.1. Pull the motor unit to your side until it stops.2. Lower the motor unit until it stops.3. And then adjust the Ø190mm saw blade so that it comes to the position shown in Fig. 16.Note: The saw blade must not contact kerf boards and base, when the motor unit is in the lowest position.4. Tighten hex bolt M6x16 using socket wrench 10.ø190mm saw bladeFig. 16Hex bolt M6x16Socket wrench 10(Standard equipment)Kerf boardR epairP 13/ 26