Menu
Makita DCU602 Instruction Manual
Also see for DCU602: Instruction manualInstruction manualInstruction manualInstruction manualInstruction manual
                                                                                                                                            |
25 ENGLISHTilt switchCAUTION: Be sure to hold the brake leverwhen you operate the tilt switch.CAUTION: Before using the tilt switch, makesure that the remaining battery capacity is notlow. If the battery capacity is low, lock the brakelever, and then switch the battery cartridges tocharged ones or replace the battery cartridgeswith charged ones.► Fig.26: 1. Tilt switchYou can tilt the bucket or carrier using the tilt switch. Totilt the bucket or carrier forward, press the upper side ofthe tilt switch while holding the brake lever. To return thebucket or carrier, press the lower side of the tilt switchwhile holding the brake lever.NOTE: The beep sound is emitted while the bucket orcarrier is moving.Adjusting the width of the carrierNOTICE: Make sure that the side rails and frontrail are fixed securely after tightening the thumbnuts.Loosen 6 thumb nuts, and then slide the side rails andfront rail. Tighten the thumb nuts to fix the side rails andfront rail.► Fig.27: 1. Thumb nut 2. RailCAUTION: Do not slide the rails beyond thelimit mark.► Fig.28Adjusting the handle heightNOTICE: Fix the left and right handles at thesame height.The handle height can be adjusted in 7 levels. To adjustthe handle height, loosen 2 knobs, then adjust thehandle height by aligning the hole on the handle withthe protrusion on the rear frame, and then tighten 2knobs securely. Adjust the height of the other handle inthe same way.► Fig.29: 1. KnobRear wheel lockYou can fix the direction of the rear wheels using therear wheel lock.1. Slightly move the machine forward so that the rearwheels face the direction shown in the figure.► Fig.30: 1. Rear wheel2. Rotate the rear wheel lock toward the rear.► Fig.31: 1. Rear wheel lock3. Lock the other rear wheel in the same way.4. Move the rear wheel back and forth or left andright slightly to make sure it is locked.To release the rear wheel lock, rotate the rear wheellock 90° as shown in the figure.► Fig.32: 1. Rear wheel lockNOTE: The rear wheels can be fixed in 4 differentdirections as shown in the figure.► Fig.33Using the levelUsing the level, you can check if the ground is level.► Fig.34: 1. LevelOPERATIONCAUTION: Be sure to lock the brake leverbefore loading or unloading objects.Operating the machineNOTICE: Be sure to insert the lock key beforethe operation. If the lock key is not inserted, a beepsound is emitted when you pull the switch trigger. Thebeep sound stops by releasing the switch trigger andpulling the brake lever.NOTICE: Perform the inspection before oper-ating the machine by referring to the section formaintenance.1. Make sure that the brake lever is locked. Installthe battery cartridges, and insert the lock key and turn itclockwise.2. Select the battery cartridges with the batteryselection switch.3. Press the power button on the control panel to turnthe power on.► Fig.35: 1. Power button4. Pull the brake lever to release the lock of thebrake lever.► Fig.36: 1. Brake lever5. Hold the handles firmly with both hands.► Fig.376. Pull the switch trigger.► Fig.38: 1. Switch trigger |
Related manuals for Makita DCU602
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved