Makita DCS9010 Instruction Manual

Also see for DCS 9010: Owner's and safety manual

Makita DCS9010 Instruction Manual Manual pdf 22 page image

22Replacing the vibration dampersCAUTION: Always switch off the engine and pull the plugcap off the spark plug (see "Replacing the sparkplug"). Always wear protective gloves!CAUTION: Start the chain saw only after having assembledit completely and inspected!Always replace all fi ve vibration dampers.- The vibration damper (E/1) is installed next to the identificationplate.- The vibration damper (E/2) is installed underneath the guidebar support. The chain catch (a) must be removed.- The vibration damper (E/5) is installed under the mountingarm of the tubular handle.- Put the saw chain on its side and carefully remove theprotective cover (G/4) by means of the universal wrench.Replacing vibration dampers 1 - 4- The vibration damper (F/3) is installed underneath the oiltank cap.- The vibration damper (F/4) is installed underneath the pre-filter. The cover (a) and pre-filter (b) must be removed.- Use the offset screw driver to loosen the screw inside.- Carefully demount the vibration damper by means of theuniversal wrench.- The vibration damper is mounted in the reverse order.- Demount the tubular handle (a) (5 screws).- Use the socket wrench (accessories, not delivered with thechain saw) to demount the vibration damper carefully.- The new vibration damper is mounted in the reverse order.Replacing vibration damper 5JaIE21 a5G H43F b a4