Makita AT638A Instruction Manual

Also see for AT638A: Instruction manual and users guide Instruction manual Instruction manual Instruction manual

6 ENGLISHAir dusterCAUTION: Do not aim the ejection port of theair duster to someone. Also, keep your hands andfoot away from the ejection port. If the air dusterbutton is accidentally pushed, it may cause a per-sonal injury.CAUTION: Always check your surroundingsbefore using the air duster. Blown dust or objectsmay hit someone.CAUTION: Do not connect or disconnect theair hose while pushing the air duster button.The air supplied to the tool can also be used as an airduster. You can clean the work area by pressing thebutton on the grip end.1► 1. ButtonNOTICE: After using the air duster, the driving forceof the tool will temporarily decline. Wait until the airpressure recovers in this case.NOTICE: Perform a test blow if you use the airduster immediately after the oil was applied. The oilmay be sprayed with the air.ASSEMBLYCAUTION: Before carrying out any work onthe tool, always return the trigger and disconnectthe air hose from the tool.CAUTION: Load the same type, size anduniform length of staples when loading multiplestrips of staples in the magazine.Loading staplerNOTE: Always hold the rear of the sliding door whenyou press the lever. The sliding door opens suddenlywith the lever pressed when staples are stored in themagazine.1. Press the lever and open the sliding door of themagazine.12► 1. Lever 2. Sliding door2. Insert a strip of staples into the opening of themagazine all the way.3. Close the sliding door until the sliding door islocked.Removing staplesTo remove staples, follow the procedures of “Loadingstapler” in reverse.Nose adapterTo prevent the surface of workpiece from beingscratched or damaged, use the nose adapter.