Makita 3710 Instruction Manual

Also see for 3710: Technical instructions Instruction manual Instruction manual Instruction manual Instruction manual

9Fig.17NOTE:• Circles between 172 mm and 186 mm in radiuscannot be cut using this guide.Align the center hole in the straight guide with the centerof the circle to be cut. Drive a nail less than 6 mm indiameter into the center hole to secure the straightguide. Pivot the tool around the nail in clockwisedirection.Fig.18Trimmer guideFig.19Trimming, curved cuts in veneers for furniture and thelike can be done easily with the trimmer guide. Theguide roller rides the curve and assures a fine cut.Loosen the wing bolts and secure the tool basehorizontally. Install the trimmer guide on the tool basewith the clamp screw (A). Loosen the clamp screw (B)and adjust the distance between the bit and the trimmerguide by turning the adjusting screw (1 mm per turn). Atthe desired distance, tighten the clamp screw (B) tosecure the trimmer guide in place.Fig.20When cutting, move the tool with the guide roller ridingthe side of the workpiece.Fig.21MAINTENANCECAUTION:• Always be sure that the tool is switched off andunplugged before attempting to perform inspectionor maintenance.• Never use gasoline, benzine, thinner, alcohol orthe like. Discoloration, deformation or cracks mayresult.Replacing carbon brushesFig.22Remove and check the carbon brushes regularly.Replace when they wear down to the limit mark. Keepthe carbon brushes clean and free to slip in the holders.Both carbon brushes should be replaced at the sametime. Use only identical carbon brushes.Use a screwdriver to remove the brush holder caps.Take out the worn carbon brushes, insert the new onesand secure the brush holder caps.Fig.23To maintain product SAFETY and RELIABILITY, repairs,any other maintenance or adjustment should beperformed by Makita Authorized Service Centers,always using Makita replacement parts.OPTIONAL ACCESSORIESCAUTION:• These accessories or attachments arerecommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory orattachment for its stated purpose.If you need any assistance for more details regardingthese accessories, ask your local Makita Service Center.Router bitsStraight bitFig.24mmD A L 1 L 220 50 1520 620E 1/4"8 68E 1/4"8 50 186 66E 1/4"6 50 18006485"U"Grooving bitFig.25mmD A L 1 L 26 66E 1/4" 6 60 28R3006486"V"Grooving bitFig.26mmD A L 1 L 21/4" 20 50 15 90006454Drill point flush trimming bitFig.27mmD A L 1 L 26 66E 1/4" 6 60 18L 328006487Drill point double flush trimming bitFig.28mmD A L 1 L 2 L 46 66E 1/4" 6 70 40L 312 14006488