Makita 3710 Instruction Manual

Also see for 3710: Technical instructions Instruction manual Instruction manual Instruction manual Instruction manual

6ENG901-1• The declared vibration emission value has beenmeasured in accordance with the standard testmethod and may be used for comparing one toolwith another.• The declared vibration emission value may also beused in a preliminary assessment of exposure.WARNING:• The vibration emission during actual use of thepower tool can differ from the declared emissionvalue depending on the ways in which the tool isused.• Be sure to identify safety measures to protect theoperator that are based on an estimation ofexposure in the actual conditions of use (takingaccount of all parts of the operating cycle such asthe times when the tool is switched off and when itis running idle in addition to the trigger time).ENH101-12EC Declaration of ConformityWe Makita Corporation as the responsiblemanufacturer declare that the following Makitamachine(s):Designation of Machine:TrimmerModel No./ Type: 3710are of series production andConforms to the following European Directives:98/37/EC until 28th December 2009 and then with2006/42/EC from 29th December 2009And are manufactured in accordance with the followingstandards or standardised documents:EN60745The technical documentation is kept by our authorisedrepresentative in Europe who is:Makita International Europe Ltd,Michigan, Drive, Tongwell,Milton Keynes, MK15 8JD, England30.01.2009000230Tomoyasu KatoDirectorMakita Corporation3-11-8, Sumiyoshi-cho,Anjo, Aichi, JAPANGEA010-1General Power Tool SafetyWarningsWARNING Read all safety warnings and allinstructions. Failure to follow the warnings andinstructions may result in electric shock, fire and/orserious injury.Save all warnings and instructions forfuture reference. GEB019-2TRIMMER SAFETY WARNINGS1. Hold power tools by insulated grippingsurfaces when performing an operation wherethe cutting tool may contact hidden wiring orits own cord. Contact with a "live" wire will makeexposed metal parts of the tool "live" and shockthe operator.2. Use clamps or another practical way to secureand support the workpiece to a stableplatform. Holding the work by hand or againstyour body leaves it unstable and may lead to lossof control.3. Wear hearing protection during extendedperiod of operation.4. Handle the bits very carefully.5. Check the bit carefully for cracks or damagebefore operation. Replace cracked ordamaged bit immediately.6. Avoid cutting nails. Inspect for and remove allnails from the workpiece before operation.7. Hold the tool firmly.8. Keep hands away from rotating parts.9. Make sure the bit is not contacting theworkpiece before the switch is turned on.10. Before using the tool on an actual workpiece,let it run for a while. Watch for vibration orwobbling that could indicate improperlyinstalled bit.11. Be careful of the bit rotating direction and thefeed direction.12. Do not leave the tool running. Operate the toolonly when hand-held.13. Always switch off and wait for the bit to cometo a complete stop before removing the toolfrom workpiece.14. Do not touch the bit immediately afteroperation; it may be extremely hot and couldburn your skin.15. Do not smear the tool base carelessly withthinner, gasoline, oil or the like. They maycause cracks in the tool base.16. Draw attention to the need to use cutters ofthe correct shank diameter and which aresuitable for the speed of the tool.