PRELIMINARY SETUP PROCEDURES GENERAL SAFETY I NFORMATION12 M86 S ECURITY INSTALLATION G UIDEGeneral Safety InformationServer Operation and Maintenance PrecautionsWARNING:Observe the following safety precautions during server operation and mainte-nance:WARNING: If the server is used in a manner not specified by the manufacturer, the protec-tion provided by the server may be impaired.WARNING: M86 Security is not responsible for regulatory compliance of any server thathas been modified. Altering the server’s enclosure in any way other than the installationoperations specified in this document may invalidate the server’s safety certifications.CAUTION: Never pile books, papers, or other objects on the chassis, drop it, or subject itto pressure in any other way. The internal circuits can be damaged, and the battery maybe crushed or punctured. Besides irreparable damage to the unit, the result could bedangerous heat and even fire.CAUTION: There are no user-serviceable components inside the chassis. The chassisshould only be opened by qualified service personnel. Never disassemble, tamper with, orattempt to repair the server. Doing so may cause smoke, fire, electrical shock, seriousphysical injury, or death.• Do not insert objects through openings in the chassis. Doing so could result ina short circuit that might cause a fire or an electrical shock.• Do not operate the server in an explosive atmosphere, in the presence of flam-mable gases.• To ensure proper cooling, always operate the server with its covers in place. Donot block any openings on the chassis. Do not place the server near a heater.• Always exit the software application properly before turning off the server toensure data integrity.• Do not expose the server to rain or use near water. If liquids of any kind shouldleak into the chassis, power down the server, unplug it, and contact M86 Secu-rity technical support.• Disconnect power from the server before cleaning the unit. Do not use liquid oraerosol cleaners.
