Lenovo C360 NT Hardware Maintenance Manual

Also see for ideaCentre C360: Hardware Maintenance Manual

Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovorecommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratchesor other damage.Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operatingsystem, and turn off the computer and all attached devices.Step 2. Unplug all power cords from electrical outlets.Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)cables, and any other cables that are connected to the computer. Refer to “Left and right views”and “Rear view” for help with locating the various connectors.Step 4. Remove the stand base. Refer to “Removing the stand base”.Step 5. Remove the foot cover. Refer to “Removing the foot cover”.Step 6. Push out the latches on both sides of the memory socket to release the memory module 1 andgently pull the memory module upward to remove it from its socket. 2 All of the memory modulescan be removed using the same procedure.Step 7. To install a memory module:a. Align the new memory module with the memory socket, then insert it and push down on thetop edge. Make sure the latches lock the memory module in place.Step 8. Reattach the foot cover and stand base.26 Lenovo C360–365 NT All-In-One ComputerHardware Maintenance Manual