Lenovo C360 NT Hardware Maintenance Manual

Also see for ideaCentre C360: Hardware Maintenance Manual

To set a Power-On Password, do the following:1. Start the Lenovo BIOS Setup Utility program (See ”Starting the Lenovo BIOS Setup Utility program” onpage 13.)2. From the Security menu, select Set Power-On Password and press the Enter key.3. The password dialog box will be displayed. Type the password, then press the Enter key.4. Re-type the password to confirm. If you typed the password correctly, the password will be installed.To change a Power-On Password, do the following:1. Start the Lenovo BIOS Setup Utility program (See ”Starting the Lenovo BIOS Setup Utility program” onpage 13.)2. From the Security menu, select Set Power-On Password and press the Enter key.3. The password dialog box will be displayed. Type the current password then press the Enter key.4. Type the new password, then press the Enter key. Re-type the password to confirm the new password.If you typed the new password correctly, the new password will be installed. A Setup Noticed confirmingthat changes have been saved will be displayed.To delete a previously set Power-On Password, do the following :1. From the Security menu, select Set Power-On Password and press the Enter key.2. The password dialog box will be displayed. Type the current password and press the Enter key.3. To delete the Power-On Password, leave each new password line item blank, then press Enter. A SetupNotice confirming that changes have been saved will be displayed.4. Return to the Lenovo BIOS Setup Utility program menu and select the Exit option.5. Select Save changes and Exit from the menu.Enabling or disabling a deviceThe Devices options is used to enable or disable user access to the following devices:USB Functions Select whether to enable or disable USB (Universal SerialBus) functions. If the functions are disabled, no USBdevices can be used.SATA Mode When this feature is set to Disabled, all devicesconnected to the SATA connectors (e.g. hard disk drivesor the optical disk drive) are disabled and cannot beaccessed.Onboard Audio Controller Select whether to enable or disable the OnboardAudio Controller. When this feature is set to Disabledall devices connected to the audio connectors (e.g.headphones or a microphone) are disabled and cannotbe used.Onboard Ethernet Controller or LAN Boot Agent Select whether to enable or disable the Onboard EthernetController, or select whether to enable or disable loadonboard PXE (Preboot Execution Environment).To enable or disable a device, do the following:1. Start the Setup Utility program (see “Starting the Setup Utility program” on page 13).2. From the Setup Utility program menu, select Devices.3. Select an option as follows:Select USB Setup, press the Enter key, then select USB Functions.Chapter 5. Using the Setup Utility 15