Lenovo BladeCenter Virtual Fabric 10Gb Switch Module Installation Manual

Also see for BladeCenter Virtual Fabric 10Gb Switch Module: User guide Hardware Maintenance Manual Product guide

Contents

Installing an SFP+ moduleThe SFP+ module provides two fiber-optic cable connectors for connecting toexternal ports. To install an SFP+ module, complete the following steps:1. Read the safety information that begins on page v and “Installation guidelines”on page 8.2. If you have not already done so, touch the static-protective package thatcontains the SFP+ module to an unpainted metal surface of the BladeCenterchassis or an unpainted metal surface on any other grounded rack component inthe rack in which you are installing the switch module for at least 2 seconds.3. Read the information in “Handling an SFP+ module” on page 15.4. Remove the SFP+ module from its static-protective package.5. Remove the protective cap, if one is installed, from the SFP+ module portwhere you are installing the SFP+ module and store it in a safe place.6. Remove the protective cap from the SFP+ module and store it in a safe place.Attention: To avoid damage to the cable or the SFP+ module, make sure thatyou do not connect the fiber optic cable before you install the SFP+ module.7. Insert the SFP+ module into the SFP+ module port until it clicks into place.8. Connect the fiber optic cable (see “Connecting the SFP+ module cable” on page20) and any cables that you disconnected earlier.Chapter 3. Installing and removing a 10 Gb SFP+ module 17