Command Function&D_ &D0 Modem ignores the DTR signal&D1 Modem returns to Command Mode after DTR toggle&D2 Modem hangs up, returns to the Command Mode afterDTR toggle&D3 Resets modem after DTR toggle&F_ &F Recall factory default configuration&G_ &G0 Guard tone disabled&G1 Guard tone disabled&G2 1800 Hz guard tone&K_ &K0 Disable flow control&K3 Enable RTS/CTS hardware flow control&K4 Enable XON/XOFF software flow control&K5 Enable transparent XON/XOFF flow control&K6 Enable both RTS/CTS and XON/XOFF flow control&M_ &M0 Asynchronous operation&P_ &P0 US setting for off-hook-to-on-hook ratio&P1 UK and Hong Kong off-hook-to-on-hook ratio&P2 Same as &P0 setting but at 20 pulses per minute&P3 Same as &P1 setting but at 20 pulses per minute&R_ &R0 Reserved&R1 CTS operates per flow control requirements&S_ &S0 Force DSR Signal High (ON)&S1 DSR off in command mode, on in online mode&T_ &T0 Ends test in progress&T1 Perform Local Analog Loopback Test&T3 Perform Local Digital Loopback Test&T4 Grant Remote Digital Loopback Test request by remotemodem&T5 Deny Remote Digital Loopback Test request&T6 Perform a Remote Digital Loopback Test&T7 Perform a Remote Digital Loopback Test and Self-Test&T8 Perform Local Analog Loopback Test and Self-Test&V &V0 Displays Active and Stored Profiles&V1 Display Last Connection Statistics&W_ &W0 Stores the active profile as Profile 0&W1 Stores the active profile as Profile 1%E_ %E0 Disable auto-retrain%E1 Enable auto-retrain+MS? Displays the current Select Modulation settingsAppendix A. Manual modem commands 45