Lenovo 30FM002VUS User Manual

Notes:• The unlock encode is a one-time password and is valid only during logon prompt (in one power-on cycle)for up to two hours.• If you click Skip, you can enter the BIOS setup menu without BIOS management authority. But certificatereset is allowed.Reset certificateThe enrolled certificate cannot be disabled. You can reset or remove it:1. Restart the computer. When the logo screen is displayed, press F1 or Fn+F1.2. Enter the BIOS menu with the certificate or skip the certification authentication process.3. Select Security ➙ Reset Certificate.4. Follow the on-screen instructions to enter the reset code provided by IT admin.Use software security solutionsThis section provides software solutions to secure your computer and information.Windows firewallsA firewall can be hardware, software, or a combination of both depending on the level of security required.Firewalls work on a set of rules to determine which inbound and outbound connections are authorized. If thecomputer is preinstalled with a firewall program, it helps protect against computer Internet security threats,unauthorized access, intrusions, and Internet attacks. It also protects your privacy. For more informationabout how to use the firewall program, refer to the help system of your firewall program.To use Windows firewalls:1. Type Control Panel in the Windows search box and then press Enter. View by large icons or small icons.2. Click Windows Defender Firewall, and then follow the on-screen instructions.Computrace Agent software embedded in firmware (for selectedmodels)The Computrace Agent software is an IT asset management and computer theft recovery solution. Thesoftware detects if changes have been made on the computer, such as hardware, software, or the computercall-in location. You might have to purchase a subscription to activate the Computrace Agent software.Use BIOS security solutionsThis section provides BIOS solutions to secure your computer and information.Wipe the storage drive dataIt is recommended that you wipe the storage drive data before recycling the storage drive or the computer.To wipe the storage drive data:1. Restart the computer. When the logo screen is displayed, press F1 or Fn+F1.2. Select Security ➙ secure wipe ➙ Enabled.3. Press F10 or Fn+F10 to save the changes and exit.4. Restart the computer. When the logo screen is displayed, press F12 or Fn+F12.5. Select App Menu ➙ secure wipe and press Enter.18 P360 Tower User Guide