KitchenAid KDTE334DSS Installation Instructions Manual

Contents

KitchenAid KDTE334DSS Installation Instructions Manual Manual pdf 14 page image

14Select UL Listed/CSA Approved twist-on wire connectors of theproper size. See the “Tools and Parts” section at the front of theguide for part details. Connect wires, black to black and white towhite, using the twist-on wire connectors.NOTE: Do not pre-twist stranded wire. Twist on wire connector.Gently tug on wires to be sure both are secured.Tighten strain relief screws to secure cord.Place wires inside terminal box. Replace the cover by inserting thehooks of the terminal cover into the slots in the floor of theterminal box and sliding the cover tight against the back wallwhere wires come in. Make sure wires are tucked inside the boxand not pinched by the cover.Then, put the terminal box back on the crossbar with the tab inplace. Use a ¹⁄₄" nut driver and the previously removed screw tosecure the terminal box to the crossbar.NOTE: Do not plug into outlet until instructed to do so.Once the terminal box has been remounted on the dishwasher,there should be some excess length or slack in the green, black,and white wires coming from the dishwasher to the terminal box.Wrap these wires over the nearby components or clip them backinto the nearby clips that they were routed through prior to yourremoving the box, to help keep them off the floor.Determine Cabinet OpeningMeasure height of cabinet opening from underside of countertopto floor where dishwasher will be installed (you will need tomeasure the lowest point on the underside of the countertop andthe highest point on the floor). Refer to “Dishwasher HeightAdjustment Chart” for wheel position and for wheel position andheight of front legs needed for your cabinet opening height.