Kimo Kigaz-150 User Manual

Contents

Kimo Kigaz-150 User Manual Manual pdf 14 page image

3. Perform a combustion analysis3.1. Prepare the instrument before the analysisDuring the measurement, the analyser must be in vertical position or in horizontal position. Do not hold theanalyser in inclined position.Before the 1st use of the analyser, a full charge of the battery must be made during 12 hours.Empty the water trap.In case of any default or damage of the instrument, Kimo After sales service shall be contacted. On theback of the analyser, there is a label with the analyser serial number. This number shall be communicatedfor every operation (technical operation or request of spare parts).3.2. Perform an analysis➢ Connect the flue gas probe to the analyser.➢ Turn on the instrument.Home screen is displayed with measurement menu highlighted.➢ Press OK.The screen with the different possible measurements is displayed.Remaining time of autozero and its progress bar are displayed at the bottom of thescreen.➢ Go to “Combustion” with up and down arrows.➢ Press OK.The screen displays the different combustibles in the analyser.➢ Select the type of used combustible by the boiler with with up and down arrows.➢ Press OK.The screen displays values of the different parameters of the analysis.3.3. Assign the analysis to a customerAt the end of the analysis, when measurements are constant, it is possible to assign it to a customer recorded in theanalyser or to unrecorded customer that should be created.➢ Press the function button “Save”.The analyser displays the list of recorded customers.➢ Select a customer with up and down arrows then press OK or create a customer (see page 21) then select it.The analyser displays the list of available boilers.➢ Select the boiler with up and down arrows then press OK or create a boiler (see page 22) then select it.The analyser backs to the measurement screen of the analyse.14 Perform a combustion analysisD2DFlueSondenetzerotools.comnetzerotools.com