Kilotech KWS 2200 Operation Manual

Contents

Kilotech KWS 2200 Operation Manual Manual pdf 14 page image

KILOTECH INC.www.kilotech.com 13CONFIG-FUNC-PERCEN setting) will be displayed, use PRINT, ACC, UNIT key to input thepercentage of samples and Press TARE key to confirm. If the calculated unit-percentage-weight isless than 0.5d, the indicator will display Pct.Er and go back to percent weighing mode, otherwise,after the reasonable unit-percentage-weight being got, the scale will go back to percent weighingmode. The got unit-percentage-weight can be saved after the power off and can be used next time.11.Check Percent (percentage compare) in Percent weighing mode:11.1 To make percentage compare function be available, CONFIG-FUNC-COMPAR menu item should setto YES, and high and low limitation of percentage should be set correctly according to following steps:11.2 In percent weighing mode, Press down DATA key more than 3s to input compare data of high and low.11.3 After HIGH being shown, 000000 will be displayed, use PRINT, ACC, UNIT key to input highpercentage number and press TARE key to confirm. Annunciator of Hi will be shown in this step. PressZERO key to exit and back to percent weighing mode.11.4 After Low being shown, 000000 will be displayed, use PRINT, ACC, UNIT key to input low percentagenumber and press TARE key to confirm. Annunciator of Lo will be shown in this step. Press ZERO keyto exit and back to counting mode.NOTE: If High number is 0 or is equal or less than low number, the comparison will be disabled.11.5 After the limitations have been set and check weight function is be active, one of annunciators HI, OK,LO will light up, and the beeper will sound according to its setting in USER-BEEP.12. BMI Working Mode12.1 To use the BMI mode. CONFIG-FUNC-BMI menu item should be set to YES.12.2 To enter BMI Working mode:8.2.1 Long press FUNC key, one of WEIGH/COUNT/PERCEN will be shown, use ACC or PRINT key toselect BMI, then press TARE to confirm go to BMI mode. When CONFIG-FUNC-ACCUMU is set tono: press BMI (ACC) key, go to BMI mode.12.3 Scale will show: “CM.xxx” (means: last input height is xxx cm) or “IN.xx.x” (means: last input height isxx.x inch) will be displayed, and to wait for input height: (1)to change height unit to cm or inch bypressing DATA key; (2) to change height number by using PRINT, ACC(BMI) keys (3)Press and holddown PRINT or ACC(BMI) key will increase or decrease number fast, (4) Press TARE key to confirmthe input. Press ON/OFF key to exit input data mode and back to BMI working mode. The range ofheight is 50-250cm(19.7-98.4inch) and default is 170cm(66.9inch)12.4 Press ACC key to select weight or BMI number to be displayed, when weight is displayed, the weightunit can be selected by pressing UNIT key, and BMI and weight unit will be displayed at same time.12.5 When current net weight is less than NLD.RNG, the indicator will go to display weight number ifCONFIG-FUNC-ACCUMU= No; or the indicator will back to original working mode ifCONFIG-FUNC-ACCUMU= Yes.