Keysight 85024A User's And Service Manual

Contents

Keysight 85024A User's And Service Manual Manual pdf 69 page image

Service 7Keysight 85024A User’s and Service Guide 69Replacing the type-N output connectorTools required:– 9/16 inch open-end wrenchRefer to Figure 7-9.1 Remove the connector body with the open-end wrench.2 Remove the male center conductor assembly from the gold plated innerconnector. Use your fingers to pull out the assembly. The small insulator mayor may not come out attached to the center conductor assembly. If it does,remove it from the old center conductor assembly and place it on the new one.If it is not attached to the center conductor assembly (it remained inside theinner connector), proceed to step 3.3 Hold the new center conductor assembly by the large round insulator, not bythe gold plated center conductor. Carefully align the new center conductorand insert it into the inner connector. Press gently until you feel it click intoplace.4 Place the new connector body and tighten with the open-end wrench.Figure 7-9 Output connector partsNOTE Refer to Chapter 6, “Replaceable Parts” on page 49 for part numbers.