Keys Fitness Triumph 8.3 Treadmill TRI-8.3t Owner's Manual

Contents

Keys Fitness Triumph 8.3 Treadmill TRI-8.3t Owner's Manual Manual pdf 14 page image

Maintenance InstructionsWARNING! Before performing any maintenance to your treadmill, always unplug the power cord from thesurge protector.CLEANINGRoutine cleaning of your Triumph-8.3t Treadmill will extend the life of your treadmill. WARNING! To pre-vent electrical shock, be sure the power to the treadmill is OFF and the unit unplugged from the wall electricaloutlet before attempting any cleaning or maintenance.AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water damp-ened soft cloth to remove excess perspiration. USE NO CHEMICALS.WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts thebelt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.DECK LUBRICATIONThe walking belt has been pre-lubricated at the factory. However, it is recommended that the walking boardbe checked periodically for lubrication to ensure optimal treadmill performance.Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the walk-ing board as far under as you can reach. If you feel signs of silicone, no further lubrication is required. If itfeels dry to the touch, follow the instructions below.Keys Fitness recommends “Lube N Walk” for cleaning and lubricating the treadmill belt and deck. Ask yourretailer or call Keys Fitness at 888-340-0482. You may also use silicone such as “Napa 8300” (available atmost NAPA Auto Parts stores).TO APPLY LUBRICANT TO THE WALKING BOARD1) Position the walking belt so that the seam is located on top and in the center of the center of the walkingboard.2) Insert the spray nozzle into the spray head of the lubricant can.3) While lifting the side of the walking belt, position the spray nozzle between the walking belt and the boardapproximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving fromthe front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 secondson each side.4) Allow the silicone to ‘set’ for one minute before using the treadmill.WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a cleantowel.14