Menu
KENT Razor PlusD28 Instructions For Use Manual
                                                                                                            | |
Contents
| 
26 9097698000(1)2008-04 Razor™ Plus D24 - D28 - C28ENGLISH INSTRUCTIONS FOR USETROUBLESHOOTINGTrouble Possible Cause RemedyThe motors do not work; no warning light turns on The battery connector (12) is disconnected. ConnectThe batteries are discharged. Charge the batteries.The machine does not moveThe machine has been turned on by using theignition key (80) and by keeping the paddle(83) pressed.Turn the ignition key (80) to “0”, then try tostart the machine without pressing the paddle(83).The brushes do not work, the red warning light(81c) is on. The batteries are discharged. Charge the batteries.The warning lights (81) lashes simultaneously.Brush motor overload Use less aggressive brushes and/or avoidworking with extra pressure turned on.There are foreign materials (tangled threads,etc.) preventing the brushes from rotating. Clean the brush hubs.Dirty water vacuuming is insuficient.The recovery tank (21) is full. Empty the tank.The hose (15) is disconnected from thesqueegee. ConnectThe vacuum grid (36) is clogged or the loatis closing. Clean the grid or check the loat.The debris tray (35) is clogged. CleanThe squeegee (25) is dirty, or the squeegeeblades are worn or damaged. Clean and check the squeegee.The tank cover is not properly closed, or thegasket (31) is damaged.Close the cover properly or replace thegasket.The solution low is insuficient. The solution tap (55) is closed. OpenThe solution ilter (54) is dirty. CleanThe squeegee leaves marks on the loor.Debris under the squeegee blades Remove the debris.The squeegee blades are worn, chipped ortorn. Replace the blades.The squeegee has not been balanced with thehandwheel (27). AdjustNOTEThe machine cannot operate without the battery charger.In case of battery charger malfunction, contact an authorized Service Center.For further information refer to the Service Manual, available at any Kent Service Center.SCRAPPINGHave the machine scrapped by a qualiied scrapper.Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to theLaw in force:BatteriesBrushes/padsPlastic hoses and componentsElectrical and electronic components (*)(*) Refer to the nearest Kent Center especially when scrapping electrical and electronic components.––––https://harrissupplyind.com - To Order Parts Call 608-268-8080 |
Related manuals for KENT 9087250020
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved